GanemiX 🧮 Calculator

FC710 Finish 1 Ultimate Spot/Panel Mix Ratio & HardenerSherwin-Williams Clearcoat

FC710 Finish 1 Ultimate Spot/Panel is a Sherwin-Williams (Sherwin-Williams) automotive refinish clearcoat. With hardener FH741/FH742/FH743, the mix ratio is Base 100 : Hardener 25 (by weight).

Mix ratio (by weight)

100 : 25
Base
FC710 Finish 1 Ultimate Spot/Panel
Hardener
FH741/FH742/FH743
Thinner
None
Pot life
See the TDS

Weight chart

BaseHardenerTotal
50 g12.5 g62.5 g
100 g25 g125 g
200 g50 g250 g
300 g75 g375 g
500 g125 g625 g

Scale readings (for 100 g of base): base 100 g → add hardener to reach 125 g

🧮 Calculate any amount with this mix

Tips for using FC710 Finish 1 Ultimate Spot/Panel

How to read the ratio and weigh it

The mix for FC710 Finish 1 Ultimate Spot/Panel is "Base 100 : Hardener 25 (by weight)". The numbers on this page are weight ratios in grams. For example, if you weigh 300 g of base, the hardener is 75 g. Put the cup on the scale and zero it, add the base, then add the hardener while watching the scale. For the second and later components, do not zero the cup again; read the scale as a running total (see the "scale reading" line above).

Choosing a hardener

The hardener for FC710 Finish 1 Ultimate Spot/Panel is FH741/FH742/FH743. Some systems let you choose fast, standard or slow hardeners by temperature, so check the manufacturer's temperature recommendations in the data sheet.

Pot life and how much to mix

Check the technical data sheet (TDS) for the pot life. Once the hardener is in, curing keeps going, so do not reuse leftover paint; dispose of it promptly.

Tips for clearcoats

The clearcoat sets the gloss and depth of the finish. Respect the flash-off time between coats and watch for dust and runs. Several thin coats are safer than one heavy coat.

Avoiding weighing mistakes

The smaller the batch, the more a small error matters. For 50 g of base, the hardener is 12.5 g. Misreading the hardener by 1 g shifts the hardener amount by about 8%. Use a scale that reads 0.1 g, and if you add too much, do not top up the others by eye; recalculate the whole batch or start again.

Clearcoats from other brands

FAQ

What is the mix ratio of FC710 Finish 1 Ultimate Spot/Panel?

with FH741/FH742/FH743: Base 100 : Hardener 25 (by weight).

Which hardener and thinner does FC710 Finish 1 Ultimate Spot/Panel use?

hardener FH741/FH742/FH743, no thinner.

How much hardener and thinner do I need for 100 g of FC710 Finish 1 Ultimate Spot/Panel?

FH741/FH742/FH743: 25 g hardener (125 g in total).

More Sherwin-Williams Clearcoats

Mix ratios are converted from the manufacturer's technical data sheet (TDS) into weight ratios you can measure on a scale. Products are reformulated from time to time, so always check the latest TDS before you mix. Product information: Sherwin-Williams official site