GanemiX 🧮 Calculator

P520A Ultra System Prime Standard (Gray) Mix Ratio & HardenerSherwin-Williams Surfacer

P520A Ultra System Prime Standard (Gray) is a Sherwin-Williams (Sherwin-Williams) automotive refinish surfacer. With hardener AC23/AC24/AC25/AC26, the mix ratio is Base 100 : Hardener 12 : Thinner 15 (by weight).

Mix ratio (by weight)

100 : 12 : 15
Base
P520A Ultra System Prime Standard (Gray)
Hardener
AC23/AC24/AC25/AC26
Thinner
R24/R25/R26
Pot life
See the TDS

Weight chart

BaseHardenerThinnerTotal
50 g6 g7.5 g63.5 g
100 g12 g15 g127 g
200 g24 g30 g254 g
300 g36 g45 g381 g
500 g60 g75 g635 g

Scale readings (for 100 g of base): base 100 g → add hardener to reach 112 g → add thinner to reach 127 g

🧮 Calculate any amount with this mix

Tips for using P520A Ultra System Prime Standard (Gray)

How to read the ratio and weigh it

The mix for P520A Ultra System Prime Standard (Gray) is "Base 100 : Hardener 12 : Thinner 15 (by weight)". The numbers on this page are weight ratios in grams. For example, if you weigh 300 g of base, the hardener is 36 g. Put the cup on the scale and zero it, add the base, then add the hardener while watching the scale. For the second and later components, do not zero the cup again; read the scale as a running total (see the "scale reading" line above).

Choosing a hardener

The hardener for P520A Ultra System Prime Standard (Gray) is AC23/AC24/AC25/AC26. Some systems let you choose fast, standard or slow hardeners by temperature, so check the manufacturer's temperature recommendations in the data sheet.

Pot life and how much to mix

Check the technical data sheet (TDS) for the pot life. Once the hardener is in, curing keeps going, so do not reuse leftover paint; dispose of it promptly.

Tips for surfacers

The surfacer evens out the base and supports the finish on top. Let it dry fully before sanding, and pick a grit that leaves no scratches that will show later.

Avoiding weighing mistakes

The smaller the batch, the more a small error matters. For 50 g of base, the hardener is 6 g. Misreading the hardener by 1 g shifts the hardener amount by about 16.7%. Use a scale that reads 0.1 g, and if you add too much, do not top up the others by eye; recalculate the whole batch or start again.

Surfacers from other brands

FAQ

What is the mix ratio of P520A Ultra System Prime Standard (Gray)?

with AC23/AC24/AC25/AC26: Base 100 : Hardener 12 : Thinner 15 (by weight).

Which hardener and thinner does P520A Ultra System Prime Standard (Gray) use?

hardener AC23/AC24/AC25/AC26, thinner R24/R25/R26.

How much hardener and thinner do I need for 100 g of P520A Ultra System Prime Standard (Gray)?

AC23/AC24/AC25/AC26: 12 g hardener, 15 g thinner (127 g in total).

More Sherwin-Williams Surfacers

Mix ratios are converted from the manufacturer's technical data sheet (TDS) into weight ratios you can measure on a scale. Products are reformulated from time to time, so always check the latest TDS before you mix. Product information: Sherwin-Williams official site