GanemiX 🧮 Calculator

PF Filler Mix Ratio & HardenerCromax Surfacer

PF Filler is a Cromax (Axalta) automotive refinish surfacer. With hardener PF Hardener, the mix ratio is Base 100 : Hardener 20 : Thinner 15 (by weight).

Mix ratio (by weight)

100 : 20 : 15
Base
PF Filler
Hardener
PF Hardener
Thinner
2K Thinner
Pot life
See the TDS

Weight chart

BaseHardenerThinnerTotal
50 g10 g7.5 g67.5 g
100 g20 g15 g135 g
200 g40 g30 g270 g
300 g60 g45 g405 g
500 g100 g75 g675 g

Scale readings (for 100 g of base): base 100 g → add hardener to reach 120 g → add thinner to reach 135 g

🧮 Calculate any amount with this mix

Tips for using PF Filler

How to read the ratio and weigh it

The mix for PF Filler is "Base 100 : Hardener 20 : Thinner 15 (by weight)". The numbers on this page are weight ratios in grams. For example, if you weigh 300 g of base, the hardener is 60 g. Put the cup on the scale and zero it, add the base, then add the hardener while watching the scale. For the second and later components, do not zero the cup again; read the scale as a running total (see the "scale reading" line above).

Choosing a hardener

The hardener for PF Filler is PF Hardener. Some systems let you choose fast, standard or slow hardeners by temperature, so check the manufacturer's temperature recommendations in the data sheet.

Pot life and how much to mix

Check the technical data sheet (TDS) for the pot life. Once the hardener is in, curing keeps going, so do not reuse leftover paint; dispose of it promptly.

Tips for surfacers

The surfacer evens out the base and supports the finish on top. Let it dry fully before sanding, and pick a grit that leaves no scratches that will show later.

Avoiding weighing mistakes

The smaller the batch, the more a small error matters. For 50 g of base, the hardener is 10 g. Misreading the hardener by 1 g shifts the hardener amount by about 10%. Use a scale that reads 0.1 g, and if you add too much, do not top up the others by eye; recalculate the whole batch or start again.

Surfacers from other brands

FAQ

What is the mix ratio of PF Filler?

with PF Hardener: Base 100 : Hardener 20 : Thinner 15 (by weight).

Which hardener and thinner does PF Filler use?

hardener PF Hardener, thinner 2K Thinner.

How much hardener and thinner do I need for 100 g of PF Filler?

PF Hardener: 20 g hardener, 15 g thinner (135 g in total).

More Cromax Surfacers

Mix ratios are converted from the manufacturer's technical data sheet (TDS) into weight ratios you can measure on a scale. Products are reformulated from time to time, so always check the latest TDS before you mix. Product information: Cromax official site